How is it selected and integrated?

The Executive Box Single Lid (CMS ElectraCon Executive) is an integrated power and data module that Zuster fits into a desk or table cut-out by hand during manufacture at our Design and Manufacturing HQ in Thomastown, Victoria.

-A matching timber veneer, or the client's choice of Zuster finish, is applied to the lid of the module by the Cabinet Maker, for a seamless finish

-The Cabinet Maker cuts a precise 339mm by 110mm hole into the top of the item to house the module

-The module is fitted, with brush-strip access for cables

-The unit is wired to connect via a floor box, or directly to a wall GPO using a 10A 3-pin starter lead

-Zuster's Colour and Finish Specialist applies the finish to the client's entire item, for a seamless, matching look

Specifications

Customisation Options

The lid is veneered to any Zuster timber finish, and the connection method is chosen at installation, whether floor box or wall GPO.

Ideal Use Case

Best suited to executive desks and boardroom tables where a single point of integrated power, USB and data access is needed, with frequent device connection and disconnection.

FAQ

Will the lid match my table's timber finish? Yes. The Cabinet Maker veneers the lid to match the grain of the table top, and Zuster's Colour and Finish Specialist finishes the whole item together, so the module reads as part of the piece rather than an addition to it.

Can this connect straight to a wall power point? Yes, via a 10A 3-pin starter lead. It can also be set up through a floor box.

What's the difference between this and the Dual Lid version? The Single Lid suits executive desks with moderate power and data needs. The Dual Lid (ADD006/ADD007) offers significantly higher capacity for larger boardroom tables.

What's the lead time for this add-on? Every piece begins its life at our manufacturing headquarters in Thomastown, Melbourne, where Zuster's own cabinet makers and upholsterers hand-craft it from raw material through to final detailing. Because your piece is made to order rather than pulled from a warehouse, it's ready in just 6 to 8 weeks, in the Zuster timber finish and fabric of your choice, built to be lived with for decades rather than years. Custom sizing and configurations are available on request, so the piece is made to fit your space, not the other way around.